THE NATURAL BEAUTY AND DURABILITY OF
GENUINE TERRAZZO FLOORS... at a Fraction of the Cost
technical specifications :Part I-General
Floorazzo Tile is manufactured from marble chips embedded in a flexible thermoset resin and then polished to a high-resolution finish. Prior to installation, Floorazzo Tile should be stored in a controlled environment inside the building for 48 hours at a minimum temperature of 70 degrees F. Pallets of tile should be broken down to facilitate the warming process. Keep all traffic off the completed floor for 24 hours.
Limited Warranty
Floorazzo Tile is warranted to be free from workmanship or material defects at the time of shipment. Any claimed defect must be received in writing by Floorazzo within the first year of installation. Under normal usage Floorazzo Tile are warranted against excessive wear in recommended applications for a period of 20 years.
Part II – Product
Floorazzo is 24” x 24” square-edged tile, 3/16” or 1/8” thick. Set on straight base, with a polished top radius, is also available. It can be specified in 4" or 6" height and 1' or 2' length. Manufactured by:
Floorazzo
215 W. Third St.
Siler City, NC 27344
Telephone: 919-663-1663
Fax: 919-663-1606
Impact hardness ASTM D-2583 121 Slip resistance ASTM D-2047 Wet
0.62
Dry
0.85
Compressive strength ASTM D-695 8,000 psi Tensile strength ASTM C-307 1,350 psi Flame spread ASTM D-84 20 Smoke generation ASTM E-622 Flaming
124
Non-Flaming
60
Fire rating Class A Water absorption ASTM C-97 0.05% Freeze thaw ASTM 6-1026 No effect Stain resistance ASTM D-2299 (cola, blood, ink, paint, oil, tea) Completely removed after 24 hours Toxicity Material Safety Data Negative Part III Execution
Substrate Preparation
Floorazzo is installed in the same manner as vinyl tile. Flatness variation shall be no greater then 1/8-inch in 10 feet. All surface irregularities are to be sanded smooth. All foreign matter that would prevent adhesion shall be removed Moisture Testing and contractor record retention is required. New concrete must have reached its final cure. Moisture emissions from concrete substrates shall not exceed 3.0 pounds per 1,000 square feet per 24 hours. An anhydrous calcium chloride 72-hour test kit is recommended. Prior to installation of Floorazzo Tile, the contractor must make a through examination of the sub-floor or wall surfaces and verify that conditions are acceptable to receive the tile. Particular attention must be given to the identification and removal of protruding objects, voids, floor sealers or any other condition that will impair the appearance after installation.
Installation
Floorazzo Tile is to be installed is strict accordance with the installation instructions provided. Tile adhesive to be used is Mapei ECO350. Tile adhesive, maintenance and detailed floor prep recommendations should be followed. For complete instructions regarding warranty, specific installation conditions and maintenance recommendations refer to the Floorazzo Tile website.
Part IV – Protection
Protective coverings shall be laid on the new installation until acceptance of the floor. Masking tape should not be applied directly to the tile.
